Sending GATEWAY remote connection request. When I type in my system name ("Pentair: 08-21-xx") as listed on the side of the protocol adapter, and my chosen password, the Connecting to Remote System window opens up, and shows the following message after a few seconds:
Switch the power on to the IntelliTouch or EasyTouch Control ® ® System Load Center.
When I start the software, the Local System box does not automatically populate with my identified system it is a blank white window with no text. Using a small flat-blade screwdriver, secure the wires with the screws. However, the ScreenLogic Connect software doesn't recognize the wireless system. The wireless link interface has a steady PWR green light and TX blinks yellow when it's receiving data. My router works fine, I reset the protocol adapter, re-booted everything. I upgraded my computer system to Windows 10 and now I can't seem to get the Screenlogic Connect to recognize my system. First, connect the cable with the ScreenLogic adapter. Quickly and easily setup circuits, pump speeds. This is probably a simple fix, but I haven't figured it out yet. There will be a connection cable inside the box. Convenient interface to configure local and remote Pentair Pool & Spa control systems that have ScreenLogic.
0 kommentar(er)
